Nacecare-solutions ST580 Manual de usuario

OWNERS MANUAL ST575/580 1205 Britannia Road East, Mississauga, ON L4W 1C7 Phone: 1-800-387-3210 Fax: 1-800-709-2896

TRACTION (Only machines with traction motor) These machines are equipped with electronically commanded traction, and continuous speed variation. To mo

CLEANING THE RECOVERY TANK •Open the hood (1). •Remove the drain tube (2) from its seat. Empty the tank through the drain tube by turning the knob a f

CLEANING THE SQUEEGEE The squeegee must be in perfect working condition to achieve a good drying process: it must be clean and its rubbers must be i

DISASSEMBLY OF THE BRUSHES (Only cylindrical brush models) •Pull the handle (4) as illustrated and release the side bar. •Unscrew the wing nut (1). •R

POLYPROPYLENE BRUSHES (PPL)These are used on all types of floors and offer good resistance to wear and to hot water (not more than 60°C). PPL is not

RECEIVING THE MACHINE Immediately check, when receiving the machine, that all the materials indicated on delivery documents have been received and als

• Water symbol indicates the water valve open signal lamp. • Battery charge level symbol. • Brush symbol indicates the brush motor switch. •

MOVING THE PACKAGED MACHINE The machine is contained in specific packing with a platform so that a forklift can move it. No more than two packing cra

PUTTING THE BATTERIES IN THE MACHINE The batteries must be housed in the battery compartment below the recovery tank. Specialists must carry out all i

BATTERY CHARGE LEVEL GAUGE The battery charge level gauge works with a microprocessor. The led display indicates the charge level: 4= maximum charge,

MANUAL BUSH INSTALLATION •Use lever (1) to lift the base (lever downwards). •Turn key (2) to OFF and remove it from the control panel (installing the

Follow these regulations carefully to avoid harm to the operator and damage to the machine. • Read the labels on the machine with attention. • Never

•Set the machine up for operation. •Check that the parking brake is released (1). •Connect the connector to the batteries (2). •Turn the main switch