Nacecare-solutions ST995 Manual de usuario

OWNERS MANUAL ST900 SERIES 1205 Britannia Road East, Mississauga, ON L4W 1C7 Phone: 1-800-387-3210 Fax: 1-800-709-2896

SOLUTION WATER Figure 25 Fill the solution tank with clean water at a temperature not more than 50° C and add liquid detergent in the proper co

The rules below have to be followed carefully in order to avoid injury to the operator and damage to the machine. ? Read the labels carefully o

This disposal must be subject to the rules which provide for its scrapping in appropriate centers. Figure 29 1. Carry out the operations for th

Figure 33 9. Press the accelerator pedal. The machine begins to move, the squeegee begins to lower itself and the brushes start to rotate. Dur

TRACTION Figure 36 These machines are equipped with electronically commanded traction, with three speeds forwards and one backwards. To move th

HORN Figure 40 The machine is equipped with a horn activated by the button on the instrument control panel. In reverse the horn works autom

Figure 42 Having finished the job and before any type of maintenance is done: 1. Close the cock (1). 2. Push the brushes base switch (2) into

CLEANING OF THE RECOVERY TANK Figure 46 1. Empty the tank through the flexible hose, unscrewing of some turns the knob and then taking off the p

FILTER AND RECOVERY TANK CLEANING Figure 50 1. Turn over forwards the seat. 2. Take the plug (1) off the recovery tank. 3. Remove the fil

BROOMS DISASSEMBLY Figure 53 1. Connect the battery connector. 2. Turn the key into position ON. 3. With the switch of brushes base up/down,

ON CONSIGNMENT OF THE MACHINE When the machine is consigned to the customer, an immediate check must be performed tonsure all the material mentioned

SQUEEGEE REAR RUBBER REPLACEMENT Figure 56 If the squeegee rear rubber is worn and does not dry well, it is possible to change the drying edge p

ADJUSTMENT SPLASH GUARDSWASHING/SCRUBBING BASE (brooms) Figure 60 Periodically proceed with the height adjustment of the side splashguards of th

INSUFFICIENT WATER ONTO THE BRUSHES Figure 63 1. Make sure that the cock is open. 2. 2. Make sure that there is water in the solution tank.

THE SUCTION MOTOR DOES NOT FUNCTION Figure 65 Check that the squeegee is in its working position and/or that the squeegee up/down switch is in

THE HORN DOES NOT WORK Check that no thermal protection is occurred. (See THERMAL PROTECTORS). EXCESSIVE FOAM PRODUCTION Check tha

POLYPROPYLENE BRUSH (PPL) It is used on all types of floors, which are hot water resistant (not more than 60°C). The Polypropylene brush is no

Symbol denoting up - down of the brushes base. It is used to indicate the switch to raise or lower the brushes base. Symbol denoting charge

HOW TO HANDLE THE PACKED MACHINE Figure 1 The machine is packed in a specific packageprovided on a pallet so that it can be moved with a forklift

Figure 5 For battery installation: 1. Lift the base support of the seat. 2. Lean the seat on to the steering wheel 3. Rotate back the recover

check the level of the electrolyte and, if necessary, top off with distilled water. LEVEL INDICATOR FOR THE CHARGE OF THEBATTERIES Figure 9 The ba

ADJUSTMENT HEIGHT SQUEEGEE SUPPORT Figure 13 The squeegee has to be regulated in height depending on the wearing of the rubbers. To adjust this it

BRUSHES ASSEMBLY Figure 17 1. Connect the battery connector. 2. Turn the key switch to the ON position. 3. With the switch raise the base. 4.

CYLINDRICAL BROOMS ASSEMBLY Figure 21 1. Connect the battery connector. 2. Turn the key into position ON. 3. Move the switch to raise the base.