Nacecare-solutions NTT2000 Manual de usuario descargar pdf

NUMATIC - NTT 2000

NOTE: As with all electrical equipment, care and attention must be exercised at all

times during its use, in addition to ensuring that routine and preventative maintenance is

carried out periodically in order to ensure its safe operation. In particular the electrical

supply cable and flexible hose should be regularly inspected by a competent person

and immediate action taken to rectify any faults found. Failure to carry out maintenance

as necessary, including replacement of parts to the correct standard, could render the

equipment unsafe and the manufacturer can accept no responsibility in this respect.

See the enclosed exploded drawings for correct replacement parts.

_____________________________________________________

MACHINE COMPONENTS

Powerhead

The 3 vacuum motors are housed within the epoxy coated steel head. To start the

vacuum, there are 2 switches - one on the front of the handle assembly, and one at the

rear. First activate the front switch. This will start two motors. Then activate the rear

switch to start the third motor. This system is used to reduce the start-up current that

would be required if all motors started at the same time. It is NOT recommended to use

the vacuum without all three motors running. If one or two motors are not running, air

will be drawn into the vacuum through the exhaust side of the remaining motors. This

will dramatically reduce the performance of the vacuum system.

The powerhead is removed by lifting up on the 4 steel toggles and releasing the claw

from the rim of the powerhead.

The exhaust port of the vacuum is equipped with a screw on diffuser to divert the

exhaust airflow. This may be removed if required. Also it is possible to fit an exhaust

hose to divert the processed vacuum air to another area. For this it is recommended to

use the shortest 2" Numatic hose possible, and to increase the diameter to proprietary

exhaust hose as soon as possible to reduce back pressure.

1 2 3 4

NUMATIC - NTT 2000NOTE: As with all electrical equipment, care and attention must be exercised at alltimes during its use, in addition to ensuring

2Standard Dry FiltersThe NTT 2000 is normally equipped with a 2 stage main filter assembly. This consistsof a red Filtrex filter providing 5.0 micron

3release the drain hose from the steel bracket on the handle of the cart and push the"ball" from the hose closure device away from the hose

4If the machine will not run, check that the it is switched on and that power is available. Ifthe machine stops in use and restarts after a time, the

Sin comentarios

Nacecare-solutions NTT2000 Manual de usuario